CATE40 Face Milling CATE Tool Holder 20CrMnTi For Cutter Bar Clamping

CATEE40 Face Milling Holder for Cutter Bar Clamping CATEE tool holder face milling cutter

CATEE tool holder FMA Face Mill Holder ,the main test bar according to international standard.CATEE Face Milling Holder used in the clamping of the cutter with the radial drive groove, such as the face milling cutter, the vertical disc cutter, the set type end mill, high speed and high precision machining .

CATEE Face Milling Holder The cutter bar requirements are as follows:
To be clamped tighter, better rigidity, small deflection accuracy of machining tool, in this case, can the effectiveness of potential play!
CATEE Face Milling Holder The cutter bar check the accuracy of the matters needing attention:
1, the accuracy of the accuracy and reliability of the scale, the unit of measurement of at least 0.002mm.
2, the main test bar according to international standard
3, the accuracy of the tungsten steel mold qualified. Control shaft diameter tolerance within H6.
4, the cutter bar in the front, thoroughly clean all parts, such as the collet nut etc.. And at the same time, should pay attention to the cleanliness of the machine spindle.
5, the cutter bar clamping tungsten steel mold bar, the need to comply with all kinds of tool rod device description of. In order to avoid clamping precision caused by improper, distortion.
6, if the measurement. 180 degree deviation, the reason may be the bolt head or mechanical spindle taper precision etc..

CATEE Face Milling Holder

CATEE face mill holder is a type of tool holder used in machining operations. It is designed to hold face mills, which are cutting tools used for milling flat surfaces. The CATEE face mill holder is specifically designed to fit the CATEE (V-Flange) spindle taper, which is a common type of spindle taper used in milling machines. The holder securely holds the face mill in place and allows for precise and accurate cutting operations.

Tool holder:
1. The shank 7:24 taper accuracy ≤ AT3 and some standard sizes are all tested on the standard inspection tool made in Germany.
2. The inner cone is tested with a standard pneumatic measuring instrument, and the contact area ratio of the big end is over 90%.
3. The shank body jumps ≤0.002.
5.CATEE Face Milling Holder the handle is suitable for medium speed precision machining
6. Dynamic balance: G6.3 12000/18000RPM G2.5 15000/25000RPM can be made according to demand. It can also be customized according to customer requirements.
7. Each FMA/FMB face milling cutter is equipped with screws and lugs for assembly of face milling cutters.
8.if you have a production plane milling cutter - extended type, you can ask.
9.CATEE Face Milling Holder material: 20CrMnTi.
10.CATEE Face Milling Holder hardness: HRC54 ° -60 °
11.CATEE Face Milling Holder Carburizing depth: >0.8.

The positive benefit:
* to shorten the processing time, increase production per unit of time.
* the overall product precision, appearance quality.
* the production cost can be reduced.
Customer trust, under the orders of the chip increase.
The cutter bar requirements are as follows:
To be clamped tighter, better rigidity, small deflection accuracy of machining tool, in this case, can the effectiveness of potential play!